I switched the B to monitor too and dragged some shapes again from A, and finally it had the right colour. Document A had RGB/8/Monitor but document B had RGB/8 only. So I realized this was the difference between the two PSDs. I must have changed something to get this, but I don't remember sorry for the lack of information, but this was several weeks of searching and trying. I often pressed that as I use hungarian keyboard, but it switches back to english from time to time, and on the "y" is swapped with "z". My photoshop used to change from RGB to CMYK by using CTRL+ Y on the header tab of the document, but now it changes to RGB/8 to RGB/8/Monitor. It’s always a good idea to work on duplicates of your original files and you may find your image looking pixelated by the end of. Step 1: Open up your image and duplicate. I checked almost everything, both documents had the same colour settings, I could not change anything in Edit > Assign Profile, both of them had the working sRGB IEC61966-2.1. In this easy-to-follow tutorial, we will see show you how to pick out colors from an image and save them into a new, custom color swatch. There were already some shapes in PSD B that had exactly the same colour overlay as the dragged in shapes and the originals in PSD A as I copy pasted the layer style. I had 2 PSD files open with some work in it, and I dragged some layers from A to B to resize the work, but the colour of the shapes changed to darker and duller. To save a step in copying a layer to a new document, Cmd-click on the layer thumbnail to select the non-transparent pixels on the layer. The remedy is to use Copy Merged (Cmd-Shift-C) rather than Copy. Option-click on the eyeball by that layer to "solo" it, and check your colors. ![]() If that is NOT the problem, then you have an adjustment layer or a blend mode (on the layer itself or one above) applied which isn't there when you move that one layer out of the layer stack into a new document. Be sure to use "Perceptual" or "Relative Colorimetric" as the method to avoid other undesirable color shifts. ![]() The solution in this case is Edit > Convert to Profile in the original. You can verify this in the original by using Edit > Assign Profile and selecting sRGB. When you force it into an sRGB document the colors are rendered differently. From the description, your source document may be using a non-sRGB color profile.
0 Comments
Leave a Reply. |